ppi 2600
Thread Starter
Le Mans Master
Joined: Nov 2004
Posts: 7,186
Likes: 45
From: detroit area
ppi 2600
is it possible to bridge this amp to one channel.... i haven't found anything on it and i don't have the manual... i'm runnin 2 jl10w6v2 from it at a 2ohm load.......
b
b
Race Director
Joined: May 2003
Posts: 14,137
Likes: 2,985
From: Iowa
St. Jude Donor '03 thru '26
I have a PPI 2150 which its two channels are bridged. I believe your 2600 is the top of the line but it will not like a 2 ohm single load, it will only do 4 ohm that way. The amp will be fine at 2 ohms running it in stereo.
Race Director
Joined: Feb 2005
Posts: 12,458
Likes: 27
Run that amp in stereo and connect the voice coils in parallel. I believe that should mean 600 watts to each sub RMS. If that isn't enough bass to blow out your ear drums, you must be bionic. 
More power to ya.
More power to ya.
Thread Starter
Le Mans Master
Joined: Nov 2004
Posts: 7,186
Likes: 45
From: detroit area
thanks..... i did did the duals in that -,- and +,+ so i'll just run it in stereo....... hopefully i'll be able to turn it on tomorrow....i have a few more items to hook up
thanks
b
thanks
b
