C6 - Kenwood install - phase IV
Thread Starter
Drifting
Joined: Dec 2004
Posts: 1,973
Likes: 55
From: OIB North Carolina
St. Jude Donor '06
C6 - Kenwood install - phase IV
I have finally installed the JL Stealth sub (and got rid of the big solobaric sitting in the back), I have also changed the amp (for the 4th time) to a new JL 500/5... Just waiting on Audio Dave for his amp rack to clean it all up... At least I am done moving / changing equipment (for now!)...
Melting Slicks
Joined: Aug 2006
Posts: 2,866
Likes: 45
From: Tampa Bay, Go BUCS!!!Go Rays!!!Go Lightning!!!
St. Jude Donor '12-'13-'14
Beautiful work. Not sure why they call them stealth boxes though 
but they are pretty.
Does your top still fit with the subs installed?
but they are pretty.Does your top still fit with the subs installed?
Thread Starter
Drifting
Joined: Dec 2004
Posts: 1,973
Likes: 55
From: OIB North Carolina
St. Jude Donor '06
I would say perfectly, and actually there is no problem, however if you look at the grill on the sub you see a dark line. That is where the side of the top just barely rests against it...
I think after I put in the amp rack, I will install the bolt for the JL in the bottom of the bin and that should cinch it down enough to not touch anymore...
I have seen a few other pics on here and that slight line is always present...
I think after I put in the amp rack, I will install the bolt for the JL in the bottom of the bin and that should cinch it down enough to not touch anymore...
I have seen a few other pics on here and that slight line is always present...
