C5 Corvette Sub Box Plans??
Thread Starter
Pro
Joined: Sep 2012
Posts: 594
Likes: 6
From: Edmond Oklahoma
C5 Corvette Sub Box Plans??
I've searched, and searched, the forum and all of the links seem to be broken. I was just wondering if i could get a link to some plans that actually works or if anyone knows how. i found one set of plans but for the slanted piece it doesnt list the angles, it tells you to play with it, and i can not get the right angels for the life of me so i was hopign someone had plans with all of the lengths and widths and angles for the few angled cuts. thank you!
Melting Slicks
Joined: Mar 2004
Posts: 2,149
Likes: 6
From: NCCO Oklahoma
Here's a link to a set I made up on AutoCAD. It lists the angles of the lower section, and I believe that the one at the top is 60 degrees as well. 
Melting Slicks
Joined: Mar 2004
Posts: 2,149
Likes: 6
From: NCCO Oklahoma
A straight cut is 90 degrees perpendicular, so a setting of 30 degrees on one side equals a 60 degree cut on the opposite side.
Hope this helps.
Thread Starter
Pro
Joined: Sep 2012
Posts: 594
Likes: 6
From: Edmond Oklahoma
must've been too early lol makes perfect sense. I just don't see why the 20.5x14.75 piece is there. is there actually supposed to be a piece there or is that just a given measurement? I can't figure out why the box would be divided by that piece. thanks!
Tech Contributor
Joined: May 2003
Posts: 7,035
Likes: 134
From: North Augusta, SC
