The Escort and the V1 use the same power cord. Any harm in mixing the detectors?
#1
Melting Slicks
![](/forums/images/ranks/3k-4k.gif)
![](/forums/images/ranks/3k-4k.gif)
Thread Starter
Member Since: Jan 2003
Posts: 3,407
Likes: 0
Received 0 Likes
on
0 Posts
![](https://www.corvetteforum.com/forums/images/ranks/cf15.jpg)
![Default](https://www.corvetteforum.com/forums/images/icons/icon1.gif)
There's no harm in using the Valentine's direct-wire cord with the Passport (the 8500 x50 arrived today), right? I don't really feel like re-routing the wire and splicing it into the auxillary harness under the pass foot panel.
Anyway, I'll be testing it out the next few days...
Anyway, I'll be testing it out the next few days...
![Cheers!](https://www.corvetteforum.com/forums/images/smilies/cheers2.gif)
#2
Le Mans Master
![](/forums/images/ranks/5k-6k.gif)
![](/forums/images/ranks/5k-6k.gif)
![Default](https://www.corvetteforum.com/forums/images/icons/icon1.gif)
As long as the voltage comes out on the same pin and it fits there shouldn't be any issues.
#3
Race Director
![](/forums/images/ranks/7k-10k.gif)
![](/forums/images/ranks/7k-10k.gif)
Member Since: May 2003
Location: Paducah KY
Posts: 19,105
Likes: 0
Received 0 Likes
on
0 Posts
Cruise-In VII Veteran
![Default](https://www.corvetteforum.com/forums/images/icons/icon1.gif)
I have both the Valentine 1 & Passsport 8500 and use the same hard wired cord/connector for either one.
There's no difference between the two.
There's no difference between the two.
![Cheers!](https://www.corvetteforum.com/forums/images/smilies/cheers2.gif)