Looking For New Ground Location
Thread Starter
Safety Car
Joined: Jan 2004
Posts: 3,551
Likes: 0
From: Making my plane take off from a treadmill
Looking For New Ground Location
hey all i'm currently using the same ground as the tranny and diff but there is alot of alternatoe noise comming through the speakers. does anyone have a better spot? if so please advise.
Racer
Joined: Aug 2001
Posts: 278
Likes: 0
From: San Diego CA
I ran 4 gauge to the passenger seat bolt and have zero engine noise. My system runs off an Optima yellow top installed in the drivers side rear storage compartment, so the power and ground runs to the amps are pretty short which also helps.
You can click on my sig and see a few install pics.
Good luck!
You can click on my sig and see a few install pics.
Good luck!
Racer
Joined: Jul 2004
Posts: 474
Likes: 14
Passenger seat bolt with 4 gauge here too. No noise. Make sure you get a good connector that has a large mouth so you can really tighten it back up - dont want a safety issue on your hands.
I used dynamat to hold the wire in place while attaching the plastic interior panel.
I used dynamat to hold the wire in place while attaching the plastic interior panel.
