Striker plate rivets
#1
Racer
Thread Starter
Member Since: Mar 2004
Location: Wellsboro PA
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
Striker plate rivets
I am replacing my deck lid striker plates. The old ones were removed during the strip and repaint process. The problem now is I can't recall if the revit heads show from the top or are inserted from below. I have a friend with aircraft hand and pneumatic squeezers. Is that what is needed to do the job?
#2
Team Owner
Member Since: Oct 2000
Location: Washington Michigan
Posts: 38,899
Received 1,860 Likes
on
1,103 Posts
Those rivets are inserted so the original finished oval heads are visible, and the peened-over shank ends are not.
#4
Instructor
I am working on reattaching the deck lid striker plates on my 64 vert and am having trouble getting the top rivet set. I got the 2 on the side of the striker plate OK, but the drip rail/gutter is at such an angle I cant get my air gun and shank at the correct angle to get a good hit on the rivet...any tricks to doing this?
All and all help is appreciated...
All and all help is appreciated...