[66] Vent cable knobs..
Thread Starter
Race Director
Joined: Jul 2002
Posts: 11,593
Likes: 173
From: Clayton NC
[66] Vent cable *****..
In the process of refurbing my vent cables as part of the interior resto. The **** on one of my pulls is damaged so I cut it off. I have the new ***** but they are not a interference fit like the originals. I tried some epoxy but it does not appear to be holding the **** to the cable. Does any one have any suggestions to how they have completed this or any other ideas? Thanks.
Dave
Dave
Race Director
Joined: Jan 2002
Posts: 15,354
Likes: 2,726
From: Close to DC
C2 of the Year Finalist - Modified 2020
Dave, Can you drill a tiny hole through each and use a piece of safety pin in it and then epoxy it. You would have too put each in a vice carefully in order to drill. If not that, try cutting some tiny serrations on the shaft. That would give the epoxy something to grip. 
Dennis
Dennis
