1967 Assembly help
Thread Starter
Racer
Joined: Jun 2006
Posts: 413
Likes: 3
From: Frankfort Illinois
1967 Assembly help
So as to not get ahead of myself and create more work in the long run I need your help and input to make sure I am going in the right direction. I got the car back from paint/body and some assembly but there is still some things I need to get done the rear wiring was already run so that has already been run up to the firewall....I just put sound/heat barrier down with some jute....
I hope to put in the rear carpet today or later this week, I have the holes marked for the seats and gas pedal. I will be turning my attention to the wiring. There is a vintage air system installed so this is where I am at and the direction I think I need to go in
1) make sure no interference with the wipers and vintage air
2)run wiring for air system and duct work
3)wire up cluster and install in dash along with the clock
4) install dash and complete the wiring
I know there are things I am forgetting and this is all uncharted territory for me thats why I am asking the help of those of you who have blazed this trail before...any and all help appreciated. Jim
I hope to put in the rear carpet today or later this week, I have the holes marked for the seats and gas pedal. I will be turning my attention to the wiring. There is a vintage air system installed so this is where I am at and the direction I think I need to go in
1) make sure no interference with the wipers and vintage air
2)run wiring for air system and duct work
3)wire up cluster and install in dash along with the clock
4) install dash and complete the wiring
I know there are things I am forgetting and this is all uncharted territory for me thats why I am asking the help of those of you who have blazed this trail before...any and all help appreciated. Jim
