C1 & C2 Corvettes General C1 Corvette & C2 Corvette Discussion, Technical Info, Performance Upgrades, Project Builds, Restorations

Big Blocks in the Dakotas

Thread Tools
 
Search this Thread
 
Old 07-10-2015, 08:58 PM
  #1  
Jackfit
Le Mans Master
Support Corvetteforum!
Thread Starter
 
Jackfit's Avatar
 
Member Since: Feb 2006
Location: Maine
Posts: 5,074
Received 408 Likes on 262 Posts

Default Big Blocks in the Dakotas

Originally Posted by 66BlkBB
Jack,

Hi, I thought you would like to look at a few big blocks that a few friends in the Dakotas have. Dan, Maroon, Pete , Yellow, and Steve , Black big blocks. I had lunch with them as I crossed the Dakotas on my 48 State Tour.

Steve asking me a question on my linkage post.

"Are you planning any more US excursions? Dan, Pete and I still own the BB's. Dan just got his repainted and setup with a new rear spring, steering box, etc. I haven't seen it yet but will try to look at it when I am in Moorhead again. Take care."

Steve


Hi Steve,

I prefer the GM rods, I was not sure if I could use them, or if in fact they are the ones that have worn out.

I am planing to go to Carlisle this year. I have never been to it , more info later as I am finishing up the rear end and suspension on the car.

Thanks again for the great lunch....

Some pictures of my visit on the 48 State Tour





















Back on the road


Last edited by Jackfit; 07-10-2015 at 09:02 PM.



Quick Reply: Big Blocks in the Dakotas



All times are GMT -4. The time now is 09:51 AM.