C1 ('59) trunk gaps?
Thread Starter
Instructor
Joined: Mar 2015
Posts: 155
Likes: 0
From: South Jordan Utah
C1 ('59) trunk gaps?
Hello, can anyone tell me what the "typical" gaps should measure on the top (deck lid side to divider bow), and the sides of a trunk lid? I have a new PM repro lid that will require trimming, as the weatherstrip lips are very much different widths side to side.... I'm also replacing the rear valance and bottom trunk opening.... is 3/8" typical on those edges? Or is that too much? Cannot find this in my Assembly manual... Thanks a bunch, Ed
Safety Car
Joined: Jul 2006
Posts: 4,606
Likes: 210
From: Nevada City Ca.
2015 C1 of Year
Hello, can anyone tell me what the "typical" gaps should measure on the top (deck lid side to divider bow), and the sides of a trunk lid? I have a new PM repro lid that will require trimming, as the weatherstrip lips are very much different widths side to side.... I'm also replacing the rear valance and bottom trunk opening.... is 3/8" typical on those edges? Or is that too much? Cannot find this in my Assembly manual... Thanks a bunch, Ed
)
Thread Starter
Instructor
Joined: Mar 2015
Posts: 155
Likes: 0
From: South Jordan Utah
. So, 3/8" gap all the way around is fairly typical then... Appreciate the info! Thanks again, Ed
Le Mans Master
Joined: Sep 2003
Posts: 8,934
Likes: 657
From: Norwalk ohio
2019 Corvette of the Year Winner
St. Jude Donor '15
You can always build up the gaps to get what you want...if making it like restored than 3/8 is probably fine, but if you are making a street Rod/or other, then tighten them babies up!
