Classic Instruments cluster installation question

Reply Subscribe

Thread Tools

Search this Thread

Aug 14, 2017 | 07:23 PM

vjjack04

Thread Starter

Melting Slicks

Joined: Apr 2007

Posts: 2,945

Likes: 1,115

From: Hereford AZ

Classic Instruments cluster installation question-now w/pics

Guys, for those who have done it, were you able to map the factory colored wires to those on the Classic Instruments harness? The one I am using has a square (Molex?) connector with all the wires from the dash going to it, and then it has the complementary connector which must be wired to the main harness. The model number of the gauge package is CO63AXG. I will post a couple pictures later....any advice from you who have done this, I'd appreciate it.

Johnny

Attached Images

Last edited by vjjack04; Aug 15, 2017 at 07:51 PM. Reason: clarity

Aug 14, 2017 | 08:21 PM

skids

Drifting

Joined: Jul 2004

Posts: 1,554

Likes: 168

From: Wi

Ironically I am going to install their gauges also, good timing on your question. There is no wiring schematic included??

Aug 14, 2017 | 11:37 PM

vjjack04

Thread Starter

Melting Slicks

Joined: Apr 2007

Posts: 2,945

Likes: 1,115

From: Hereford AZ

Quote:

Originally Posted by skids

Ironically I am going to install their gauges also, good timing on your question. There is no wiring schematic included??

There is a diagram...its just that the thing is already wired and has this "molex" connector whereas my new American Autowire harness has a couple different types...plus I am an amateur at wiring....i will have to take a picture tomorrow... but it does look like I have to just cut off what they have a use the classic instruments connector....here is the manual:

http://www.classicinstruments.com/us...n%20010615.pdf

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last

Forum Jump