63 turn signal problem
Thread Starter
Pro
Joined: Jun 2011
Posts: 588
Likes: 41
From: Ohio
63 turn signal problem
On my 63 the turn signal housing moves when the lever is turned for left or right. This is not a new issue but has done it since I purchased the car. Another C2 buddy said the "alignment wedge" must not have been installed if the previous had the steering column apart. I have found vendors who carry a replacement but I have no idea where it goes or how to get into the sleeve area. Even with the AIM it doesn't say much about the wedge. Any help would be greatly appreciated..thanks
Burning Brakes
Joined: Oct 2005
Posts: 999
Likes: 99
From: Captain Cook Hawaii
As you sit in the drivers seat, feel around the housing, at the 10 o'clock position there is an indent. There should be a screw there. [the wedge will be on the inside thus not seen] If the screw is there try and tighten. Please get back to us.
Rene
Rene
Thread Starter
Pro
Joined: Jun 2011
Posts: 588
Likes: 41
From: Ohio
GOOD CALL !!! I found the screw and was able to turn it about 3/4 to 1 full turn and the housing does not move . Thanks a bunch for that tip. Forum members never cease to amaze me.
