1961 Corvette Turn Signal Column Wire Connector
#1
Tether Man
Thread Starter
Member Since: Dec 2004
Location: Pittsburgh, South Hills
Posts: 4,621
Received 2,085 Likes
on
1,069 Posts
2023 C2 of the Year Finalist - Modified
2022 C2 of the Year Finalist - Unmodified
2019 C1 of Year Finalist (appearance mods)
1961 Corvette Turn Signal Column Wire Connector
Actually swiped this from a previous thread........Looking for replacement connectors 61 Turn Signal Switch/Column wiring.
Are these still made? I can't seem to locate them........
Thanks...
Last edited by dcamick; 05-06-2019 at 09:18 AM.
#2
Team Owner
That's a pic of my '61 wiring. I don't know who makes those, maybe call Lectric Limited or else one of the restomod guys may have some left over from a build...
The following users liked this post:
dcamick (05-06-2019)
#3
Tether Man
Thread Starter
Member Since: Dec 2004
Location: Pittsburgh, South Hills
Posts: 4,621
Received 2,085 Likes
on
1,069 Posts
2023 C2 of the Year Finalist - Modified
2022 C2 of the Year Finalist - Unmodified
2019 C1 of Year Finalist (appearance mods)
#4
Team Owner
You might want to consider two male/female 3-way sets of these - if you can verify that the stock connectors will install in them tightly (third row of products shown):
https://www.clipsandfasteners.com/O-...ells-s/259.htm
https://www.clipsandfasteners.com/O-...ells-s/259.htm
Last edited by Frankie the Fink; 05-06-2019 at 09:44 AM.
The following users liked this post:
dcamick (05-06-2019)