[C2] Installed valve stem height difference - problem?
Thread Starter
Drifting
Joined: Dec 2014
Posts: 1,761
Likes: 138
From: Chantilly Virginia
No shortage of problems, drop crank in block this coming week with goal of road test by Memorial Day! Have not done this since 1963 on my '54 Ford V8. Cylinder heads have gotten heavier since then! Mass of the earth must have increased. 
Safety Car
Joined: Oct 2016
Posts: 4,617
Likes: 1,547
From: Olive branch Ms
I have gotten so much weaker I can't lift a torque converter over my head laying under the car. When I slid the tranny out I had to call my grandson to come help me pick it up. I said these things didn't weigh this much when I was younger. They are a little heavier but I'm a LOT weaker.
Thread Starter
Drifting
Joined: Dec 2014
Posts: 1,761
Likes: 138
From: Chantilly Virginia
I have gotten so much weaker I can't lift a torque converter over my head laying under the car. When I slid the tranny out I had to call my grandson to come help me pick it up. I said these things didn't weigh this much when I was younger. They are a little heavier but I'm a LOT weaker.
Last edited by After38Years; May 2, 2020 at 08:14 PM.
