ignition switch
Thread Starter
Pro
Joined: Jun 2011
Posts: 588
Likes: 41
From: Ohio
ignition switch
Had to replace ignition lock on my 63. I tightened the 3 notched lock bezel and installed new lock cylinder. Tested key and it turned pretty hard and wouldn't release from the start position. Took lock back out and backed off the bezel and now key works ok. i have the bezel only finger tight . Is the bezel supposed to be tight or can i just leave it finger tight? I don't want to screw the cluster panel or the switch up. thanks
Instructor
Joined: Oct 2008
Posts: 210
Likes: 53
There are a couple of different nuts, the 66-67 is taller, maybe you do not have the right one? Do you have an aftermarket switch? If so, you need to have the depth set properly. .
Last edited by BWT; Jun 15, 2023 at 07:04 AM. Reason: Check
1967 Pedal Car Champion
Joined: Mar 2020
Posts: 9,263
Likes: 4,329
From: US-PNW
Le Mans Master
Joined: Nov 2015
Posts: 7,510
Likes: 2,663
From: Really Central IL Illinois
Unless the switch housing is moving around in the hole, it is tight enough. Of course if it does move with key motion, it will eventually cause some wear in the hole or switch housing. I can't offer a solution as I have never had this problem.
