is this the right fan for my 64?
#1
Instructor
Thread Starter
Member Since: Jul 2020
Location: cutchogue long island n.y.
Posts: 248
Likes: 0
Received 58 Likes
on
32 Posts
is this the right fan for my 64?
i have a 64 coupe with a 365hp engine. the nose has been replaced with what i believe to be a 66 nose. this is the fan that was on the engine. can anyone tell me if it is correct for a 64?
#2
Team Owner
Member Since: Feb 2003
Location: Sitting in his Nowhere land Hanover Pa
Posts: 49,197
Received 7,027 Likes
on
4,830 Posts
2015 C2 of Year Finalist
The rivets and the markings look correct. What is the overall size of the fan. It should be 17 1/8
#3
Instructor
Thread Starter
Member Since: Jul 2020
Location: cutchogue long island n.y.
Posts: 248
Likes: 0
Received 58 Likes
on
32 Posts
@Nowhere Man look at the pic with the tape. it is almost 9 to the center. my car dose not have a/c. would the fan clutch have numbers or marking on it?
#4
Le Mans Master
@Nowhere Man look at the pic with the tape. it is almost 9 to the center. my car dose not have a/c. would the fan clutch have numbers or marking on it?
#5
I agree with Leif, 18" fan blade used on the A/C cars, the round head rivets were used in the early sixties and I believe that fan was also used on the 409 Impala.
If the car is not a factory A/C car it would not be correct but I think it would work fine. There must be an engineering reason why the fan blades on the Corvettes were 1" smaller, maybe noise.
If the car is not a factory A/C car it would not be correct but I think it would work fine. There must be an engineering reason why the fan blades on the Corvettes were 1" smaller, maybe noise.