Making Progress!!
Thread Starter
Race Director
Joined: Jan 2000
Posts: 13,014
Likes: 2,257
From: Corsicana, Tx
2020 C2 of the Year - Modified Winner
2020 Corvette of the Year (performance mods)
C2 of Year Winner (performance mods) 2019
2017 C2 of Year Finalist
Making Progress!!
I pulled oil pan off Sunday to do a little "post dyno flog" survey to make sure everything was OK. Thankfully, the bearings still looked like I had just installed them and the valves were all still set just right. I adjusted a couple of them ,but it was only the difference between a "tight" feel and a "normal" feel on the same feeler gauge. All looked great.
I cleaned it up and dropped it into the car last night. Then I installed trans, shifter and driveshaft (hey all the new stuff fits...so far!).
It sure looks better in the car than it did on the stand!
JIM
I cleaned it up and dropped it into the car last night. Then I installed trans, shifter and driveshaft (hey all the new stuff fits...so far!).
It sure looks better in the car than it did on the stand!
JIM
