Quest for SWCDuke
Thread Starter
Drifting
Joined: Feb 2000
Posts: 1,550
Likes: 0
From: Naples, Fl. USA
Quest for SWCDuke
I tried to locate the thread in the archives regarding your posts about the LT1 cam, with no luck.
I can't remember if you actually posted a part number for the cam, or if anyone else knows the correct number.
Any help is much appreciated.
:seeya
I can't remember if you actually posted a part number for the cam, or if anyone else knows the correct number.
Any help is much appreciated.
:seeya
Thread Starter
Drifting
Joined: Feb 2000
Posts: 1,550
Likes: 0
From: Naples, Fl. USA
Re: Quest for SWCDuke (clem zahrobsky)
Is this the GM part#, or an aftermarket no. ?
As I remember the thread- it said GM no longer serviced this cam, and some other cos. were making a repo.
As I remember the thread- it said GM no longer serviced this cam, and some other cos. were making a repo.
Race Director
Joined: May 2000
Posts: 12,712
Likes: 2,270
Re: Quest for SWCDuke (clem zahrobsky)
Federal Mogul Speed Pro clone is CS1145R. Use with the F-M AT840R lifters, which are equivalent to the original 5231585 "edge orifice" lifters.
E-mail me if you want the document that describes the proper valve lash specs and adjusting procedure.
Duke
E-mail me if you want the document that describes the proper valve lash specs and adjusting procedure.
Duke
