Distributor Replacement
Melting Slicks
Joined: Jan 2003
Posts: 2,817
Likes: 21
From: Somerset, NJ
Just unloosen the hold down bolt and move the hold down to the side and lift it out. I would do it with the distributor cap off. Before you unloosen the bolt and pull the distributor out spin the motor over to get the brass striker part of the distributor rotor to face the firewall so that you know where to have the rotor sit on the other distributor when you reinstall it so it drops right in.
Fred
Fred
Thread Starter
Advanced
Joined: Apr 2005
Posts: 77
Likes: 0
From: Va Beach VA
I want to replace my distributor I just want to make sure i don't do anything wrong. what is the correct method to make sure everything is lined up coorect when i put the new one in.
thanks
thanks
Melting Slicks
Joined: May 2003
Posts: 2,253
Likes: 1
From: Rochester Kent
Originally Posted by buckethead
I want to replace my distributor I just want to make sure i don't do anything wrong. what is the correct method to make sure everything is lined up coorect when i put the new one in.
thanks
thanks
