Will this stuff work?
Thread Starter
Safety Car
Joined: Oct 2006
Posts: 3,930
Likes: 15
From: Calgary Alberta
Will this stuff work?
I just ran out of paint stripper and happened to have a whole can of this stuff left over from when I was restoring a pool table.
http://www.homedepot.ca/webapp/wcs/s...k=P_PartNumber
Has anyone used this stuff before on fiberglass? What were the results like?
Please, for you people who do not recommend any paint stripper for corvettes, do not post in this thread.
http://www.homedepot.ca/webapp/wcs/s...k=P_PartNumber
Has anyone used this stuff before on fiberglass? What were the results like?
Please, for you people who do not recommend any paint stripper for corvettes, do not post in this thread.
Racer
Joined: Jan 2005
Posts: 389
Likes: 1
From: Sarasota Florida
I would give it a shot, I used aircraft stripper on my 68 and had no issues. You just have to pay close attention to the time you leave it on the surface. Test it leaving it on for a very short time, and see how the finish comes off, adjust from there. I have stripped three Vettes so far and used liq stripper on everyone, no big deal unless you lose track of time and leave it on for too long. Good Luck
