It been a long time since I've added any updates to my project. Between house reno's, coaching a roller derby team and homework, it ate all my time up. Roller derby is done and the reno's stalled so I now have some pics to post. I finally have the front clip glued on thanks to my buddy Dan and Joe. Dan is on here as Dannyman and Joe...well...he doesn't have a Vette yet. Both great guys and patient I tell you, I was picky. I also have the new rims and tires on the car. They're Boss 338's and Falken 452's. The back offset is perfect, I can even use my sway bar with the 275/40/18's but the front I think needs to go out a bit. Here's the pics. The side pipe is hanging low so I can get the clip on and off easier. I also put rubber mounts on the car so it's sitting a little high.



There's a story and lesson to this mess. Make sure you have the right year vacuum canister because it's not coming out in one piece if the clip is glued. I had to take it out because it was pushed against the firewall wiring harness connector. Nobody caught that one until it was too late. I had to use one of those hacksaw blade holders and cut the whole thing up and pull it out the side gill hole.



Here's an old video of the dyno

 

Looking good Rob.

502 hp is pretty sweet too!