1981 Wiper wiring HELP!!!
Thread Starter
Melting Slicks
Joined: Jul 2013
Posts: 3,237
Likes: 31
1981 Wiper wiring HELP!!!
When working on my wiper motor the plastic clip that retains the three wires that go into the wiper motor came off (snagged on my cuff and pulled loose). Need help making sure what the proper position of the three wires should be. Can anyone confirm?
Currently I have in the clip (from top down) but these were only a guess.
1: White wire (could be tan can't tell its 32 years old)
2: 2nd White wire with resistor
3: Red wire with resistor
I just received a new wiper module (upgraded one) and don't want to plug it in until I am sure I have the wires in the proper position.
Below is a pic of what I have but I DON'T KNOW IF IT IS CORRECT.
[IMG]
[/IMG]
Currently I have in the clip (from top down) but these were only a guess.
1: White wire (could be tan can't tell its 32 years old)
2: 2nd White wire with resistor
3: Red wire with resistor
I just received a new wiper module (upgraded one) and don't want to plug it in until I am sure I have the wires in the proper position.
Below is a pic of what I have but I DON'T KNOW IF IT IS CORRECT.
[IMG]
Last edited by mrscott25; Aug 16, 2013 at 07:07 PM. Reason: Adding pic of wiper question
