C3 hood scoops
#1
Advanced
Thread Starter
Member Since: Jan 2011
Location: Winona Mo.
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
C3 hood scoops
I know it may be blasphemy, but I'd like to see some pictures of C3's with hood scoops. It usually looks goofy to me when I see a scoop on top of a bulge, I'd like to see some that are tastefully done. My 72 is a small block base engine car and there isn't much room for the air cleaner with an aluminum intake.
#3
Melting Slicks
The Motion hood is the only one I've seen that looks half decent.
#4
Safety Car
#5
Le Mans Master
Member Since: May 2003
Location: Fernandina Beach FL
Posts: 8,481
Received 3,220 Likes
on
1,732 Posts
2023 Restomod of the Year finalist
2020 C3 of the Year Winner - Modified
What about this?
Not on a C3- but it's a FAT stinger hood- I am actually looking at something like this for my crossrams-
DSCN4811 by richardhayes454, on Flickr
I like this one-
This pretty cool- a Shaker-
Not on a C3- but it's a FAT stinger hood- I am actually looking at something like this for my crossrams-
DSCN4811 by richardhayes454, on Flickr
I like this one-
This pretty cool- a Shaker-
#8
Advanced
Thread Starter
Member Since: Jan 2011
Location: Winona Mo.
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
I think the shaker from the T/A is pretty cool, I had wondered if anyone had done that. I agree with Kid Vette, the Motion hood looks as good as any I've seen.
#13
Drifting
#17
#20
I've posted these pics before, but just in case you haven't seen them. I really need better pictures.
Here's my '68 with a '67 BB scoop on the '68 SB hood. The scoop itself is the same as seen on the Motion car. The PO started it, and I knew I'd need the clearance so I went with it. I like it a lot, but I'd also really like an uncut SB hood and accept the limited intake options...just think they look the cleanest.
Like the Motion car in this post, I prefer them without the stripes...especially if the hood is screaming for attention. I have a SB with RPM Air Gap and a flat base 3" air cleaner element.
Here's my '68 with a '67 BB scoop on the '68 SB hood. The scoop itself is the same as seen on the Motion car. The PO started it, and I knew I'd need the clearance so I went with it. I like it a lot, but I'd also really like an uncut SB hood and accept the limited intake options...just think they look the cleanest.
Like the Motion car in this post, I prefer them without the stripes...especially if the hood is screaming for attention. I have a SB with RPM Air Gap and a flat base 3" air cleaner element.