Removed rear bumper cover.
10-22-2016, 09:24 PM
#1
Drifting
Thread Starter
Removed rear bumper cover.
I had a chance today to remove the rear bumper cover on my 1980. Tomorrow I'm going to attempt to install the new one.
10-23-2016, 05:45 PM
#3
Drifting
Thread Starter
The following users liked this post:
havesometo (10-23-2016)
10-23-2016, 06:56 PM
#5
Drifting
Thread Starter
I bought it from a forum member and was told it was made by Toledo Pro.
It's a flex fit. I'm not sure if he bought it from Eckler's Corvette or not but he said they sell them.
10-23-2016, 07:53 PM
#6
Race Director
Member Since: Nov 2006
Location: Athens GA
Posts: 19,446
Received 351 Likes
on
304 Posts
St. Jude Donor '12-'13, '15- '16-'17-'18-'19, '21
Nice job Kenny...I hope I can get my project bumper to match up that well.
Glad it worked out for you.
Yes it was made by Toledo Pro years ago. I believe they got bought out.
Eckler's and Willcox both used to carry their stuff.
Good tolerances and great quality.
Bman (Dennis)
Glad it worked out for you.
Yes it was made by Toledo Pro years ago. I believe they got bought out.
Eckler's and Willcox both used to carry their stuff.
Good tolerances and great quality.
Bman (Dennis)
The following users liked this post:
havesometo (10-23-2016)