Fs: Auto tranny and manual clutch parts
#1
Melting Slicks
Thread Starter
Fs: Auto tranny and manual clutch parts
I sold off my corvette so I need to get rid of my extra parts. Please shoot me a PM or email if you have any questions.
- TRANSMISSION 700R4 manual shifting built up big time, started slipping before I switched to a manual tranny 27 spline in put shaft C4 tailhousing(easy to swap out), with speed sensor $50 + shipping
- TORQUE CONVERTER 2500 stall, my old engine builder uses the same kind in his 9 second drag car, 27 spline input shaft, lock-up $50 + shipping
-MCLEOD TWIN DISK CLUTCH slightly used with new master cylinder ZF-6 pressure plate with GEN1(2 piece rear main) flywheel, missing throw out bearing $250 shipped
Thanks,
MN_Vette
- TRANSMISSION 700R4 manual shifting built up big time, started slipping before I switched to a manual tranny 27 spline in put shaft C4 tailhousing(easy to swap out), with speed sensor $50 + shipping
- TORQUE CONVERTER 2500 stall, my old engine builder uses the same kind in his 9 second drag car, 27 spline input shaft, lock-up $50 + shipping
-MCLEOD TWIN DISK CLUTCH slightly used with new master cylinder ZF-6 pressure plate with GEN1(2 piece rear main) flywheel, missing throw out bearing $250 shipped
Thanks,
MN_Vette
Last edited by mn_vette; 12-19-2009 at 09:27 AM.