shrek66

I am looking for the side which holds the evaporator not the blower side.
I think the range for the case is 74 - 79.

thanks

Todd

danh77

I may have what your after. I got it from a guy on here as I was missing something, which at this point I don't even recall what it was, anyway I believe I got it for shipping charges. Anyway let me take a look and see if it's still here and I would have no problem moving it on to you for shipping cost if I still have it and it's what your after. I'll take a look tomorrow and if I have it I'll snap some pics.

danh77

This is what I have. I think it's from a 76 but not 100% on that as I've had it quite awhile. If you think part of this is what your needing let me know as I can take any part off it or if there is a part # somewhere on it I can check for you so you know if it will work

corvette74

Is this what you are looking for?









Dale

shrek66

This is what I am looking for. In the picture it is the cover on the right hand side. There are three lines coming out and then going into the cylinder on the left. There are 6 larger screws and one small screw holding the two sides together. When separated, the A/C condenser is inside and held in place with three screws. I only need the fiberglass case the condenser is in.

Thanks so much.

pm me with cost/questions.

Todd

danh77

Todd, I was a bit confused by your reply as to what's left/right. I thought you wanted the cover to the left but your reply says right. Regardless I tried to pm but couldn't put a pic with it. I split the case apart to eliminate any confusion so here's 2 more pictures.

danh77

And here's the other half. I do see some part numbers also if that helps

shrek66

This is the part I am looking for. It has the Harrison sticker on it.

Let me know.

Todd