FS: Mallory duel point distributer
#1
Pro
Thread Starter
Mallory duel point distributer
Selling this Used Mallory duel point distributor #2648201 with Tach drive & mechanical advance. I took this off my '74 corvette, it was put on by the previous owner, worked fine before pulling it to rebuild the engine. I decided to go with HEI so I won't be using it. The unit works but will need to be cleaned up (maybe scotch-brite the aluminum, new cap/rotor etc). It has "newer" Taylor spiral core 8 mm wires with no cuts or burn's with just oil/grease smudges that can be cleaned off. A MSD blaster 2 coil with a stock intake manifold coil bracket. I also have a used resistor & aluminum firewall mount as well?
the spark plug wires where cut to fit and the wires ran behind the valve covers then down the bottom edge of the valve covers dropping off at each cylinder around the headers on a R&M wire loom plate (i'm keeping those to re-use) this is the loom:
( https://www.summitracing.com/parts/r...FclLDQod_RkMRw)
could be a good ignition system for someone on a budget that needs a set up like this?
what you see is what you get... $SOLD SOLD SOLD!!!
thanks,
Paul
the spark plug wires where cut to fit and the wires ran behind the valve covers then down the bottom edge of the valve covers dropping off at each cylinder around the headers on a R&M wire loom plate (i'm keeping those to re-use) this is the loom:
( https://www.summitracing.com/parts/r...FclLDQod_RkMRw)
could be a good ignition system for someone on a budget that needs a set up like this?
what you see is what you get... $SOLD SOLD SOLD!!!
thanks,
Paul
Last edited by Lyndwood; 04-26-2017 at 09:54 PM.