WTB: Lt1-71
#1
5th Gear
Thread Starter
Member Since: Jun 2016
Location: Brisbane, Australia
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
71 LT1 R/H exhaust Manifold
Correct 71 LT1GM correct Corvette 2 inch right hand exhaust manifold with air injection holes wanted
Last edited by C3-LT-1; 03-04-2019 at 05:01 AM.
#2
The only small block corvettes to use a 2-1/2 ram horn were the 64-66 HP cars...
70-72 LT1's used a 2" manifold just like every other car... except they are drilled for SMOG tubes.
The head pipes are swaged 2 to 2-1/2 the best looking reproduction of that pipe is made by Gardner.
70-72 LT1's used a 2" manifold just like every other car... except they are drilled for SMOG tubes.
The head pipes are swaged 2 to 2-1/2 the best looking reproduction of that pipe is made by Gardner.
#3
Safety Car
The only small block corvettes to use a 2-1/2 ram horn were the 64-66 HP cars...
70-72 LT1's used a 2" manifold just like every other car... except they are drilled for SMOG tubes.
The head pipes are swaged 2 to 2-1/2 the best looking reproduction of that pipe is made by Gardner.
70-72 LT1's used a 2" manifold just like every other car... except they are drilled for SMOG tubes.
The head pipes are swaged 2 to 2-1/2 the best looking reproduction of that pipe is made by Gardner.
The following users liked this post:
firstgenaddict (02-28-2019)