Door panel installation
Thread Starter
Safety Car
Joined: Sep 2005
Posts: 4,226
Likes: 643
From: Orange County Ca
Door panel installation
How are 69 door panels secured? I'm pretty sure that the 3" sheetmetal screws--some slotted and some phillips, with 1" fender washers--that some jerk off installed, are not the way to go. I have seen on ebay door panel attachment clips. They look like sheetmetal, about 1"x3" and screw to the door and hook on to the inside of the panels somehow. Where would these be placed? Also, there are a couple of 1/2"x1" plastic pads on the door and the old panel that snap together. I've seen these before, and they are sometimes a problem. Any other options or replacements? The 2 screws on the inside pull strap look like the only secure anchors.
Team Owner
Joined: Jun 2000
Posts: 38,923
Likes: 1,482
From: Southbound
Cruise-In II Veteran
You need the '69 assembly instruction manual (AIM); pictures of everything there. You should find two metal clips secured with sheet metal screws and three or four trim screws in the upper rear corner of each panel. You will need to remove the window crank if you do not have power windows and you will need to remove the door opening handle. "Velcro" fasteners on the backside of the trim panel hold the panel in several places.
Advanced
Joined: Nov 2004
Posts: 88
Likes: 0
From: Schuyler Nebraska
Originally Posted by Easy Mike
You need the '69 assembly instruction manual (AIM); pictures of everything there. You should find two metal clips secured with sheet metal screws and three or four trim screws in the upper rear corner of each panel. You will need to remove the window crank if you do not have power windows and you will need to remove the door opening handle. "Velcro" fasteners on the backside of the trim panel hold the panel in several places.
Instructor
Joined: Nov 2005
Posts: 133
Likes: 0
I doubt 69's are different, my 76 had c-clips just like every other crank I've pulled off. They were a little bit harder to get to due to the fact that they were closer to the handle itself than the door (which meant there was a nice lip in the way and I could hardly get ahold of the clip!). The locks were the same. Good luck!
