Working on headlights...questions
Thread Starter
Racer
Joined: Aug 1999
Posts: 451
Likes: 2
From: Toronto On
Working on headlights...questions
I'm working my way forward in the engine compartment.
Pretty much all the hoses and wires have been cleaned up, and the engine is ready to go back together.
I put in a new headlight harness (Bubba had used some thick RED wires to patch some bad grounds - idiot.).
Should I clean up the headlight assemblies "while I'm at it"? I guess I could repaint the actuators a nice silver, blast and paint the
light assemblies, etc, OR can this wait til later (after rad is in)?
Is it ok to yank the headlights up from the down position to work on them? I thought it was a no-no?
Thanks,
Jim
Pretty much all the hoses and wires have been cleaned up, and the engine is ready to go back together.
I put in a new headlight harness (Bubba had used some thick RED wires to patch some bad grounds - idiot.).
Should I clean up the headlight assemblies "while I'm at it"? I guess I could repaint the actuators a nice silver, blast and paint the
light assemblies, etc, OR can this wait til later (after rad is in)?
Is it ok to yank the headlights up from the down position to work on them? I thought it was a no-no?
Thanks,
Jim
