Hydraulic roller cam conversion
Thread Starter
Safety Car
Joined: Nov 2005
Posts: 3,961
Likes: 573
From: Lompoc, CA. Santa Barbara County
Hydraulic roller cam conversion
Before anyone yells at me, I already did a search. If it's been covered, I'd appreciate a link.
My next project is to convert to a hydraulic roller LT4 Hot Cam. The conversion lifters are over $400, but there is a guy on ebay selling instructions for $20 to use all GM parts for a fraction of the cost. Here:
http://cgi.ebay.com/ebaymotors/Chevy...spagenameZWDVW
Anyone here done this? How many miles so far, and any problems?
Bee Jay
My next project is to convert to a hydraulic roller LT4 Hot Cam. The conversion lifters are over $400, but there is a guy on ebay selling instructions for $20 to use all GM parts for a fraction of the cost. Here:
http://cgi.ebay.com/ebaymotors/Chevy...spagenameZWDVW
Anyone here done this? How many miles so far, and any problems?
Bee Jay
Team Owner
Joined: Oct 2004
Posts: 23,831
Likes: 10
From: Springfield MO
St. Jude Donor '07
http://forums.corvetteforum.com/show...=roller+lifter
I have a set of the directions, they are quite comprehensive. I just need to get some lifters so I can start working on it.
I have a set of the directions, they are quite comprehensive. I just need to get some lifters so I can start working on it.
Thread Starter
Safety Car
Joined: Nov 2005
Posts: 3,961
Likes: 573
From: Lompoc, CA. Santa Barbara County
I just heard from the guy selling the instructions. You have to yank and disassemble the engine. It's worth the $400 lifter to not have to do that. I got less than 5k miles since my rebuild.
Bee Jay
Bee Jay
