Temp sending unit
Thread Starter
Heel & Toe
Joined: Jan 2005
Posts: 19
Likes: 0
Temp sending unit
Is it possible to use the same in-block tempature sending unit to work the gage and activate an electric fan? I know I can use the type sensor that mounts in the radiator, but would prefer the sensor in the block, but only have 1 place to install it.
Safety Car
Joined: Aug 2001
Posts: 4,883
Likes: 11
From: North Easton Mass
It depends on how you are controlling the fan. The SPAL controllers are supposed to work with the factory sensor and allow you to progam the low and high fan settings. If you are using some other type of controller the fan manufacturer should have some suggestions for hooking up the sensor.
Rick B.
Rick B.
