found for sale on another forum

this a copy and paste some parts missing cause unimportant..

It has ported 990 rectangle port heads ( LS7 ) with roller rockers and fresh valves.
12 to 1 compression ratio, steel rods, .. Calies crank ( aftermarket )
4 bolt mains, BHJ (SFI approved) ballancer, Stef's aluminum pan, billit pump, cast alum. covers.
It was freshened with 700 dollar Childs and Albert Zero-gap rings. It has a solid cam as Terry wasn't a fan of Big cams.
It ran 8.70s steady with a best et of 8.60 in his roadster.
This engine has no intake and I am only selling it because I am selling my Camaro drag car and already bought a compete small block Vette drag car.
If you are like me and do not trust many people or have been taken by crooks in the past....I can drop the engine off at Pandosy Machine and Mark can dismantle it and check it out, but I can't pay for that...but I will take it there and bring it back.
The engine should make an honest 650 horse and 550 torque with a good intake and 850 to 100 cfm carb on gas. If you went to a roller cam, much more power.
I'm not sure where you live,,,but I can help with delivery.

I have a freind that is local to this engine and could check it out for me.
My question is have yuo guys heard of Callies Crank
http://www.callies.com/
or childs and albert
http://www.childs-albert.com/

Thanks guys