406 & ST-10 Installed
Thread Starter
Le Mans Master
Joined: Oct 2001
Posts: 5,943
Likes: 3
From: Wildwood IL
406 & ST-10 Installed
Install went by the book...by the numbers, with no issues, problems, OR mistakes. That's Mike (SRAY454) lending a guiding hand. THANKS AGAIN MIKE!! With new polly motor & trans mounts, and a removeable crossmember...it was a breeeeze. I do admit I was very nervous while nearly 500 LBS was hanging over those fragile fiberglass fenders. 
Now for the fun stuff to install.
The end, or should I say the beginning is near!!! VAROOOOM!!!
Hangin & ready
That big orange thing goes in here
Tip way up and let-er-down
Resting comfortably in her nest after the transplant
Special thanks to all Forum guys that have assisted me in the building of this motor. The info provided here was immeasurable.
Eddie
Now for the fun stuff to install. The end, or should I say the beginning is near!!! VAROOOOM!!!
Hangin & ready
That big orange thing goes in here
Tip way up and let-er-down
Resting comfortably in her nest after the transplant
Special thanks to all Forum guys that have assisted me in the building of this motor. The info provided here was immeasurable.
Eddie
Eddie, when's blastoff ? 
Thread Starter
Le Mans Master
Joined: Oct 2001
Posts: 5,943
Likes: 3
From: Wildwood IL
