68 Head light Bar
Thread Starter
Burning Brakes
Joined: Jan 2007
Posts: 1,057
Likes: 4
From: Concord Calif
68 Head light Bar
I'm ready to put my head lite bar back in. So I'm not going to use the rivets but do I bond the bar to the nose of the car or sould I use the bonding strip also? Not sure why I should use the bonding bar cept if there is not enough adjustment on the head lites without the bonding strip. Any opinons on this? Thanks Manuel
Thread Starter
Burning Brakes
Joined: Jan 2007
Posts: 1,057
Likes: 4
From: Concord Calif
Drifting
Joined: May 2003
Posts: 1,634
Likes: 2
From: Melbourne, Victoria, Australia, the World
Manuel,
I did not do the actual repacement myself but i believe the body man just glued the bare metal to the bonding strip. I would be worried about paint adhesion to the metal if it was painted then glued.
I did not do the actual repacement myself but i believe the body man just glued the bare metal to the bonding strip. I would be worried about paint adhesion to the metal if it was painted then glued.
