Need wiring help
Thread Starter
Drifting
Joined: May 2001
Posts: 1,651
Likes: 13
From: Holly MI
Need wiring help
When I pulled the dash out to put in my electrical tach, I found several of the wires for dash lights were dangling free. Does anybody know where I can get the mushroom shaped crimp that goes on the end of the wire? I have been told that if those crimps come off, the only way to fix it is buy a new harness, but I know this can't be true. If worst comes to worst, I'll solder something up. However, has anybody else had to do this? Any ideas? :confused:
Team Owner
Joined: Jun 2000
Posts: 38,923
Likes: 1,481
From: Southbound
Cruise-In II Veteran
Re: Need wiring help (bb69)
You can occasionally find them at swap meets. The last time I saw a bunch, I bought them. They are hard to find. Good hunting. Check with Lectric Limited. They make a good many of the repro wiring harnesses and have to be able to get them from somewhere.
:)
:)
Thread Starter
Drifting
Joined: May 2001
Posts: 1,651
Likes: 13
From: Holly MI
Re: Need wiring help (Easy Mike)
I checked on Lectric Limited's website, and under "FAQ's", they specifically state that they do not sell any connectors, tape, etc not listed on the page. They make a point of saying do not call or email about such components. I'd rather not spend $415 for a harness when there is nothing else wrong with mine. Does anybody have another vendor in mind that might help?
