Defroster duct question
#1
Melting Slicks
Thread Starter
Defroster duct question
I have the dash out of my car to replace all of the heater and A/C vacuum hoses, replace the headlight switch, and replace all the bulbs while I'm at it. While taking the duct work out I noticed that the bottom of the defroster duct has a open space between it and the main duct for the heating system. This doesn't look right to me, I think it should be connected and I think it explains why hardly any air blows out of the defroster vent. Does anyone have a picture of this so that I can see if anything is missing. You can see what I'm talking about in the photo below. Thanks.
#4
Instructor
Member Since: Jun 2000
Location: Bakersfield CA.
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
Im doing my 75 dash and I had the same question?, why dosent this fit?. so I added some alumenium dock tape and seeled it up tight.
just glad to know that Im not the only one that has ran into this problem/question.
just glad to know that Im not the only one that has ran into this problem/question.
#9
I have the dash out of my car to replace all of the heater and A/C vacuum hoses, replace the headlight switch, and replace all the bulbs while I'm at it. While taking the duct work out I noticed that the bottom of the defroster duct has a open space between it and the main duct for the heating system. This doesn't look right to me, I think it should be connected and I think it explains why hardly any air blows out of the defroster vent. Does anyone have a picture of this so that I can see if anything is missing. You can see what I'm talking about in the photo below. Thanks.
#11