rocker performance
Thread Starter
Intermediate
Joined: Nov 2006
Posts: 47
Likes: 0
From: Orlando Florida
rocker performance
does anyone know if we can put those fancy aluminum higher ratio rocker arms in a 454. will they fit under the valve covers??? what is the stock ratio for the rockers 1.6 or 1.7? if we go up .1 ratio will the valves hit the pistons? does anyone know without having to properly use clay and check clearances????? 
Race Director
Joined: Jan 2000
Posts: 13,022
Likes: 2,265
From: Corsicana, Tx
2020 C2 of the Year - Modified Winner
2020 Corvette of the Year (performance mods)
C2 of Year Winner (performance mods) 2019
2017 C2 of Year Finalist
Stock is 1.7. Depending on cam, springs etc you could go to 1.8's..especially on intake side to make a little more power.
I think the Comp Pro Magnums will fit under stock covers...but they are full roller steel...not aluminum. I have them on my motor and they do well. Worst case is you might have to use two gaskets or an extra thick one.
Truthfully though, with a milder cam there is no need for anything more than the stamped ones. The factory long slots worked well even with the L-88's and LS-7's.
JIM
I think the Comp Pro Magnums will fit under stock covers...but they are full roller steel...not aluminum. I have them on my motor and they do well. Worst case is you might have to use two gaskets or an extra thick one.
Truthfully though, with a milder cam there is no need for anything more than the stamped ones. The factory long slots worked well even with the L-88's and LS-7's.
JIM
