Tach circuit board - 76
Thread Starter
Heel & Toe
Joined: Oct 2001
Posts: 15
Likes: 0
From: East Wenatchee WA
Tach circuit board - 76
I installed my new tach circuit board yesterday but it did not fix the problem, tach needle doesn't budge when engine running. The tach filter has been removed sometime in the past and I have checked the electrical inputs, all are working fine. The new circuit board gets hot very quickly when the engine starts, like 10 seconds. The old board had several of the solder connections burnt. Any ideas? Thanks!
Team Owner
Joined: Jul 1999
Posts: 65,492
Likes: 230
From: Orange Park Florida
Re: Tach circuit board - 76 (RED76)
Like to help, but if you are not an ET, it's hard to....
I am, but trying to tell you how to use a voltmeter, and or measure a diode or circuit board is really hard, near impossible over typing internet...
even more so over the phone....
if you don't know what you are looking at, and able to 'dope' it out, then it's a hard spot....
you need someone in your local vette club to help out....every club must have a geek member somewhere...;-)))
GENE
I am, but trying to tell you how to use a voltmeter, and or measure a diode or circuit board is really hard, near impossible over typing internet...
even more so over the phone....
if you don't know what you are looking at, and able to 'dope' it out, then it's a hard spot....
you need someone in your local vette club to help out....every club must have a geek member somewhere...;-)))
GENE
