LM 1 installation???
Thread Starter
Racer
Joined: Mar 2008
Posts: 315
Likes: 0
From: KY
LM 1 installation???
I am getting ready to install the LM 1 air fuel kit
The ends on the harness that go to the exhaust are pretty big
So where did you all cut the hole for the o2 sensor to get the harness to the exhaust
Did you all run into any surprises when installing this kit
thanks
The ends on the harness that go to the exhaust are pretty big
So where did you all cut the hole for the o2 sensor to get the harness to the exhaust
Did you all run into any surprises when installing this kit
thanks
Race Director
Joined: Dec 1999
Posts: 19,610
Likes: 778
From: Forked River NJ
I drilled a hole in the pipe just after the collecter and welded the bung in there. Works great. I just run the harness out the side and under the door. The weather strip allows the cord to run into the cockpit with no probelm. The laptop and the rest of the wiring sit on the passenger seat or my sons lap.
Racer
Joined: Jan 2008
Posts: 291
Likes: 15
From: Virginia Beach VA
I just marked the location on the collector where I wanted it and then took the header to a muffler shop and then had them weld it on.. I'm pretty sure the guy did it for free... Corvette fan...
Burning Brakes
Joined: Apr 2008
Posts: 825
Likes: 40
From: Glasgow, Scotland
Race Director
Joined: Dec 1999
Posts: 19,610
Likes: 778
From: Forked River NJ
They do sell an adapter for going inside the pipe but as said above there is to much chance for contamination. I guess if you were to stick it way down it would be OK but I would think if you are driving the car it could fall out.
