Fuel Sender Wiring
Thread Starter
Race Director
Joined: Jan 2004
Posts: 18,191
Likes: 145
From: Snake handler
Fuel Sender Wiring
I just replaced my fuel sender with a repop - (It was the last original part 
).
My original had threaded rods where the harness hooked up. (wiring is not original...). The new one has no threads - it looks like the factory harness has little boots that fit over these and sort of clip on.
However, I was looking at the harnesses from Zip and they seem to have three wires - my system only has two. Is one a ground that I might be missing? I'm searching for my wiring schematic but thought I'd ask the real experts....
). My original had threaded rods where the harness hooked up. (wiring is not original...). The new one has no threads - it looks like the factory harness has little boots that fit over these and sort of clip on.
However, I was looking at the harnesses from Zip and they seem to have three wires - my system only has two. Is one a ground that I might be missing? I'm searching for my wiring schematic but thought I'd ask the real experts....
Le Mans Master
Joined: Mar 2001
Posts: 6,640
Likes: 287
From: Ann Arbor Michigan
My 71' has only 2 wires, the one with the boot that fits over the post, and a ground that connects to a ground tab on the sending unit. The replacement harness (also from ZIP) was identical to the OE one.
