At the Machine Shop
Thread Starter
Burning Brakes
Joined: Oct 2000
Posts: 779
Likes: 1
From: Minneapolis MN
At the Machine Shop
I dropped my block and heads off at the machine shop today.
Doing:
Bore & Hone
Deck (0)
Align Hone
Cam Bearings
Resize Rods
Balance Assem
Pin Fit Pistons
I'm also going to have them do the heads, go to 2.19/1.88 valves and do a 3-angle valve job. I told them to hold off until I can find out more about what I need to do with the valve guides.
Ouch! Expensive!
But it sure will be fun.
Doing:
Bore & Hone
Deck (0)
Align Hone
Cam Bearings
Resize Rods
Balance Assem
Pin Fit Pistons
I'm also going to have them do the heads, go to 2.19/1.88 valves and do a 3-angle valve job. I told them to hold off until I can find out more about what I need to do with the valve guides.
Ouch! Expensive!
But it sure will be fun.
Safety Car
Joined: Aug 2000
Posts: 3,909
Likes: 26
From: Clymer PA
Re: At the Machine Shop (ddn)
I'm going through the same thing right now! You are correct it is a bunch of fun. Were you going to have the block hot tanked? 2.19/1.88 valves are definetly the way to go.
