Heater Core
Thread Starter
Advanced
Joined: Dec 2007
Posts: 74
Likes: 0
Heater Core
My heater core was never connected to the hoses when I got the car. It's time mechanically to address this problem. Due to the fact that it was disconnected I'm assuming the worst. Is there a way to test the core before I start taking the car apart. Is there some kind of pressure test I can perform to determine if the core has a leak. Thanks
Melting Slicks
Joined: Dec 2006
Posts: 2,669
Likes: 3
From: Kingston Ontario
Sure you can pressure test or vacuum test. Hard to get the core to operating temp to simulate normal operation. Personally I would remove it and have it re-cored at a rad shop; and then you know you can expect some longevity/reliability. 
Le Mans Master
Joined: Jan 2003
Posts: 6,575
Likes: 1
From: Tuttle OK
Cruise-In VIII Veteran
You just did Paul. Why chime in just to bitch?
Just askin'...
...Anyway, I believe that the real question was...
If it were me, I'd probably just change it out.
However, if I testing it was my goal, I'd probably test it with water and a bit of pressure.
Just askin'...
...Anyway, I believe that the real question was...
However, if I testing it was my goal, I'd probably test it with water and a bit of pressure.
Just swap it out, I think mine was $36
Team Owner
Joined: Aug 2000
Posts: 42,930
Likes: 18
From: Sydney, Australia
CI 6-7-8-9-10 Veteran
St. Jude Donor '07-'08-'09-'10-'11-'12-'13-'14-'15-'16-‘17, '22
But the search feature has had a few problems recently... And people who are new to certain aspects of this hobby have to start somewhere. 
One of the other members of this board can reply if you don't feel like it.
One of the other members of this board can reply if you don't feel like it.
