axles
Thread Starter
Drifting
Joined: Apr 2006
Posts: 1,911
Likes: 2
From: gold coast queensland
axles
on a chev 10 bolt diff (8.5) if i had slight wear on the spot where the bearings roll and i lathed it ever so slightly to remove this wear do you think that would be enough to stuff the O.D. size of the axles and it wouldnt sit well in the bearing and cause a vibration or do you think it will be ok .
if i remove my wheel and grab the axle hub and move it from side to side and up and down and have no movement ...would it be safe to say the axle is ok?
if i remove my wheel and grab the axle hub and move it from side to side and up and down and have no movement ...would it be safe to say the axle is ok?
Last edited by gingerbreadman1977; Jul 20, 2009 at 05:48 AM.
