Brake Caliper Question
Thread Starter
Melting Slicks
Joined: Feb 1999
Posts: 2,473
Likes: 10
From: New Paltz, New York USA
Brake Caliper Question
I am trying to put new seals in my 81 calipers. I have no problem with the inner seal, but the outer seal needs to be pressed in. Well, I bought a press and still can't get them in straight. I think its because the caliper itself is rounded and does not sit flat on the press base. Is there a special tool for this? TIA
Safety Car
Joined: Jun 2004
Posts: 4,370
Likes: 222
From: Beecher Illinois
I use the white PVC plumbing unions and a hammer to beat the seals in. Fronts use a 1 1/2" fitting and the rears use a 1" fitting.
I did have a heck of a time with my last rebuilds, tho. Used "Dorman" kits, chinese made, and had some problems getting the outer seals in. Like they were slightly too big.
I did have a heck of a time with my last rebuilds, tho. Used "Dorman" kits, chinese made, and had some problems getting the outer seals in. Like they were slightly too big.
Thread Starter
Melting Slicks
Joined: Feb 1999
Posts: 2,473
Likes: 10
From: New Paltz, New York USA
Thanks KapsSA,
I was thinking that maybe my seals were a little to big. I bought them from Advance, I am going to try a set from NAPA and see if they fit better.
I was thinking that maybe my seals were a little to big. I bought them from Advance, I am going to try a set from NAPA and see if they fit better.
