T56 driveshaft
Thread Starter
Race Director
Joined: Dec 1999
Posts: 19,610
Likes: 778
From: Forked River NJ
T56 driveshaft
What are you guys using for a driveshaft and ujoints. Most of the T56s have a 27 spline output with a 1310 ujoint. The driveshafts are using 1330 ujoints. I know they make a 1310-1330 ujoint. The 2 piece Turbo 350 yoke is a 1310. Anyone just use a 1 piece 1330 27 spline yoke. I have been using the 1 piece yoke on my Tremec for years and just press the ujoint in/out. Any thoughts?
Thread Starter
Race Director
Joined: Dec 1999
Posts: 19,610
Likes: 778
From: Forked River NJ
Le Mans Master
Joined: Sep 2000
Posts: 9,078
Likes: 7
From: DFW TX
Cruise-In VII Veteran
St. Jude Donor '07
You will have to shorten it. The problem most run into is the 350 yoke wants to hit the tunnel. There are a few yokes out there that have rounded edges or clearances.
The crossmember is a no brainer, just cut out the center section of the stock member and peice in some plate steel to your liking. You will have to re-low the e-brake cable at the end of the project for proper fitments.
The crossmember is a no brainer, just cut out the center section of the stock member and peice in some plate steel to your liking. You will have to re-low the e-brake cable at the end of the project for proper fitments.
