81' High/Low Beam Problem
Thread Starter
4th Gear
Joined: Dec 2006
Posts: 4
Likes: 0
81' High/Low Beam Problem
Pull the headlight **** out, both lamps pop up but only one low beam light comes on. Pull the turn signal arm back to go to high beam and all four lights come on. Is it in the multifunction switch? How ugly is it to remove?
Thanks for any advice.
Thanks for any advice.
Race Director
Joined: May 2006
Posts: 16,528
Likes: 53
From: Dayton, Ohio
One of the low beam filaments is burned out or a bad connection on the tan wire at the bulb.
Each low beam bulb has 2 filaments inside one for low beam and 1 for high beam ,thats why in high beam mode the bulb lights up.
Each low beam bulb has 2 filaments inside one for low beam and 1 for high beam ,thats why in high beam mode the bulb lights up.
