Ball joint grease boot

Reply Subscribe

Thread Tools

Search this Thread

Nov 10, 2011 | 12:15 PM

Will's'74VetteL-82

Thread Starter

Pro

Joined: May 2010

Posts: 737

Likes: 3

From: Pennington NJ

Ball joint grease boot

Hello. I am greasing the chassis of my car today and had something unexpected happen. I greased a few of the ball joints and steering parts with my pneumatic grease gun, and about 2 of them started to drip grease out of the side of the boot, not around the edge where it is supposed to. Did I do any damage by "popping" the boot? All of the suspension parts are new.

Will

Nov 10, 2011 | 12:38 PM

MelWff

Race Director

Joined: May 2006

Posts: 18,784

Likes: 2,598

unless there is a obvious tear in the rubber, no. The boots are fully pushed on?

Nov 10, 2011 | 12:51 PM

Will's'74VetteL-82

Thread Starter

Pro

Joined: May 2010

Posts: 737

Likes: 3

From: Pennington NJ

Quote:

Originally Posted by MelWff

unless there is a obvious tear in the rubber, no. The boots are fully pushed on?

Yes the boots are fully on, and it seems to be almost a pinhole "leak", it's not a huge gash or hole.

Will

Nov 10, 2011 | 01:15 PM

rugerm44

Burning Brakes

Joined: Aug 2005

Posts: 801

Likes: 1

If the joints tight and has no play in it I wouldn't worry too much.I drove an old car in high school and put another 40,000 miles on it that did the same thing.Just keep it greased.It's just a,little messy.No emergency.

Nov 10, 2011 | 01:18 PM

Will's'74VetteL-82

Thread Starter

Pro

Joined: May 2010

Posts: 737

Likes: 3

From: Pennington NJ

Quote:

Originally Posted by rugerm44

Alright cool, thats what I was thinking. Upon further inspection, only one boot did this and the hole is miniscule, it will serve as a "overflow" if anything. All of the boots seem to be holding the grease, even the one with the pinhole, so all is good.

Thanks,
Will

Reply Subscribe