Roll Bar for a '77 C3?
Pro
Joined: Jul 2001
Posts: 704
Likes: 10
From: Blairsville Ga
Racer
Joined: Aug 2000
Posts: 434
Likes: 3
From: Cleveland Ohio
I put in a 4 point bar from Autopower. Fit was good. Only had to cut 1 - 2 inches off each leg for it to fit. I am running a full interior. If the interior was not going back in the car I may not have had to cut on the bar.
Safety Car
Joined: Nov 2008
Posts: 3,720
Likes: 556
From: Seattle Washington
I don't remember who's I used other than "West" was in the name. I shortened the Legs as said above and recently moved the Crossbar higher to allow the rear compartment doors to open. I'm also running a full Interior. If I was to do it again I would probably get a C3 specific kit and or only have them Tac Weld the Bar.
Melting Slicks
Joined: Dec 1999
Posts: 2,116
Likes: 156
From: Mid West
Cruise-In III Veteran
Racer
Joined: Aug 2000
Posts: 434
Likes: 3
From: Cleveland Ohio
I checked my picture files but currently do not have any pics. Let me see what I can do in the next few days. The funny thing is I completely refurbished the interior but the only pictures I took were of the bare interior and not the finish product.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
