Power Steering Control Valve
Thread Starter
Burning Brakes
Joined: Aug 2000
Posts: 952
Likes: 0
From: Morgantown,WV USA
Power Steering Control Valve
My control valve is seeping and I am going to change it. I have been shopping around and there is a wide range of prices on these things- everywhere from the low $100 range at Corvette America (for example) to nearly $200 at Advance Auto (both are remanufactured).
Anyone have any suggestions as far as where to get a good quality reman at a good price?
Thanks,
Dan
Anyone have any suggestions as far as where to get a good quality reman at a good price?
Thanks,
Dan
Drifting
Joined: Dec 2004
Posts: 1,714
Likes: 42
From: Austin Texas
I just did mine and its not a fun job. The bad part is that the first replacement leaked as well so I had to ship it back and get another.
If I could go back in time, I would buy it from a local place like advance, autozone or someone local with a lifetime warranty. If it ever fails you just walk in and return it no shipping or bs.
If I could go back in time, I would buy it from a local place like advance, autozone or someone local with a lifetime warranty. If it ever fails you just walk in and return it no shipping or bs.
Former Vendor
Joined: Aug 2006
Posts: 76,656
Likes: 1,853
From: Jeffersonville Indiana 812-288-7103
St. Jude Donor '08-'09-'10-'11-'12-'13-'14-'15
I build them in-house... http://willcoxcorvette.com/product_i...oducts_id=1307
I'd say it's more of a messy job vs a hard job..
But you can rebuild it..
Here is the rebuild kit... about 20.00.
http://willcoxcorvette.com/product_i...oducts_id=1014
Here is the stud kit below (rarely needed) 44.00.
http://willcoxcorvette.com/product_i...oducts_id=6443
Here is the deluxe kit and again it is rare to need all of this. 70.00
http://willcoxcorvette.com/product_i...ducts_id=27244
And last of all... . Here is how to do it..
and with the parts good and clean you should be albe to assemble in about .45 minutes to an hour..
Power Steering Cylinder Rebuid video
I'd say it's more of a messy job vs a hard job..
But you can rebuild it..
Here is the rebuild kit... about 20.00.
http://willcoxcorvette.com/product_i...oducts_id=1014
Here is the stud kit below (rarely needed) 44.00.
http://willcoxcorvette.com/product_i...oducts_id=6443
Here is the deluxe kit and again it is rare to need all of this. 70.00
http://willcoxcorvette.com/product_i...ducts_id=27244
And last of all... . Here is how to do it..
and with the parts good and clean you should be albe to assemble in about .45 minutes to an hour.. Power Steering Cylinder Rebuid video
Last edited by Willcox Corvette; Sep 16, 2012 at 10:08 AM.
Melting Slicks
Joined: Sep 2010
Posts: 2,414
Likes: 59
From: Emerald Isle NC
Rebuild yours. Not difficult, and plenty of references. I used one from CSSB.It's on their website (somehow has disappeared from my faves).
Get the full rebuild kit, the one with the new ball stud.
Rebuild kit: < $100
Rebuild experience: priceless
Get the full rebuild kit, the one with the new ball stud.
Rebuild kit: < $100
Rebuild experience: priceless
